Node:fstest, Next:geometry, Previous:find, Up:Command-line and menu entry commands
| fstest | Command |
Toggle filesystem test mode.
Filesystem test mode, when turned on, prints out data corresponding to
all the device reads and what values are being sent to the low-level
routines. The format is <partition-offset-sector,
byte-offset, byte-length> for high-level reads inside a
partition, and [disk-offset-sector] for low-level sector
requests from the disk.
Filesystem test mode is turned off by any use of the install
(see install) or testload (see testload) commands.
|